Usual Installation and Servicing of Vibrating Feeder

Vibrating Feeder can feed the lump, grains material evenly and continuously to the accepting set. In sand making line, vibrating feeder can feed the material evenly and continuously avoiding the blockage of crusher feeding mouth. Vibrating feeder has the features of simple structure and operation, no need lubricant and low power consumption; it can adjust the feeding quantity evenly. It is widely used in mine, macadam court, metallurgy, construction, chemical, mine, core industry, etc.

Broken production line of vibrating feeder of the installation points three conditions:

When running two sets of vibration motor must reverse spin. If current appear unstable or a loudly noise, should stop soon.

Vibrates the feeding machine maintenance:

Run before all bolts should be a vibration motor, especially the anchor bolt, continuous operation 3-5 hours should be retightened once.

Motor bearing is the broken production line of vibrating feeder mouth key equipment, so for its maintenance especially important also. The simple case every 2 months filling the lubricating oil, high temperature season every month should be filling the lubricating oil. And every half year motor to have to tear open repair a, internal bearing will change.

Level installation: This type of installation is generally applied to materials uniform stable feeding. It can prevent their material. Slope down10 degrees. This type of installation is used in general raw material continuously feeding.

Slope downward 15 degrees: This type of installation is applicable to viscous or large water raw material continuously of feeding.

Vibrates the feeding stimulus should be paid attention to during the situation:

Always check the amplitude of vibration motor, if discovery is unusual, shall be immediately stop. This is because of the vibration motor current and motor surface temperature requirements, not even before and after the amplitude about wave set.

china vibrating feeder: http://www.mine-crusher.com/vibratingfeeder.htm